If necessary, you can raise this setting, to 5 or 6 for instance. This means that by default a switch port is deemed an uplink if more than 4 devices are found connected to it. The setting is located in the Switch scanning section of the menu and is called: "A network interface will be set as an "Uplink" when more than X connected devices have been scanned (default 4)"Īs mentioned previously and in the setting name, the default value is 4. This setting can be configured per scan server, in the Configuration > Server Options menu of the web console. Customize uplink settingįrom version 9.3 onward, Lansweeper has a setting to customize when a switch port is deemed to be an uplink. If you have a server connected to a port for instance, and that server is hosting lots of virtual machines, you may need to raise the uplink setting in order to see all connected devices on the port. However, there may be situations where you want to raise this setting. In most cases, the label "uplink" will be correct for switch ports with more than 4 connected devices. An uplink is a port on a router or switch that is designed to connect to another router, switch or internet access device. If there is a match, the switch port not only shows the MAC address of the connected device but also a link to the device's Lansweeper webpage.īy default, if Lansweeper finds more than 4 devices connected to a switch port, it deems that port to be an uplink. It also tries to match these connected MAC addresses with network devices already present in the Lansweeper database. Specifically, Lansweeper pulls a list of connected MAC addresses from SNMP OIDs on the router or switch. When Lansweeper scans a router or switch using SNMP, it also tries to detect the assets connected to the device's network interfaces.
0 Comments
Leave a Reply. |